If you are having problems with your coin mechanisms such as a misaligned coin wheel or your machine will not accept your tokens, this guide will help walk you through taking your mechanism apart and putting it back together.
Recommended Supplies
- Screwdriver. We recommend THIS flexible ratcheting screwdriver for the hard to reach screws.
- Containers to separate screws
- Rag to clean off tools
- Lubricating grease for the gears if needed
Using the diagram below, you are going to want to remove all screws (6) except for the one in the middle left holding parts (12) and (13). Save screw part (10) for last. Slowly unscrew (10) and place to the side. Gently separate the back plate (4) from the front plate (2). Pull the coin wheel (3) off of the front plate (2). Check to make sure the coin detector (12) and the coin detector sprint (15) are properly in place as shown in diagram (I). Place the coin wheel (3) back on in the correct orientation. Reverse your steps (this is best done with a partner).
Any linked products include an Affiliate link which we receive a commission for any purchases made.
Leave a comment (all fields required)